passlock-sl2
Transcription
passlock-sl2
INSTALLATION GUIDE PASSLOCK-SL2 Made in Canada - Rev. P - 05 / 12 / 2008 We b s i t e : h t t p : / / w w w. i f a r. c a Copyright © 2006, FORTIN AUTO RADIO INC - ALL RIGHTS RESERVED BYPASS MODULE FOR PASSLOCK I AND PASSLOCK II, SATURN, HUMMER H2, VATS AND NEW GENERATION See wiring schematic configuration WIRING / CONNECTION GUIDE Green Ground (-) Blue (-) While running Data In Barillet Orange/Black Data from BCM Orange Bulb test Out Purple/White Purple Key sense Out Yellow/Black Starter or accessory Yellow Ignition or accessory Programming Button 2 1 Red Black Blue White LED 12V Batterie (+) OUTPUT N.C. Connector 2 (White): (I) Locate the wiring type for the vehicle on the VEHICLE FIT GUIDE (P.3) (II) Make the connections associated with the vehicle in the WIRING SCHEMATIC CONFIGURATION (P.3) 2 3 Plug in the connector 1 (black) on the PASSLOCK-SL2 1 2 Press and hold the programming button. Plug the connector 2 (white) into the PASSLOCK-SL2 interface. 5 OFF Release the programming button. IGN 6 START 7 Turn the key to the ignition position. The LED will flash rapidly. You have 4 seconds to: OFF Connector 1 (Black): Determine the type of installation: INSTALLATION WITH DATA-LINK (See plan 1, Below). INSTALLATION WITHOUT DATA-LINK (See plan 2, Below). 1.B INPUT Data-Link Data-Link Make the connections of the PASSLOCK-SL2 to the vehicle: 1.A Connect wire to RemoteStarter/Alarm INSTALLATION AND PROGRAMMATION INSTRUCTIONS START HERE 1 Connect wire to vehicle 8 IGN Start the vehicle with the key. START 9 The LED will flash (1-6 times). OFF interface. The LED will turn on, indicating the beginning of programming. 4 INSTALLATION WITH DATA-LINK Plan 1 In Data-Link mode the analog Inputs (Unlock, ground out) are disable for security. Starter or alarm Data Link Port 2 1 10 IGN START Turn the key OFF. THE PASSLOCK-SL2 IS PROGRAMMED. INSTALLATION WITHOUT DATA-LINK Plan 2 Cut off one plug of the Data-Link connector, connect the red wire to +12V and the green wire to ground. Starter or alarm 2 Red +12V 1 TECHNICAL SUPPORT / INFORMATION Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be install by qualified technician. This instruction guide may change without notice. Visit www.ifar.ca to get latest version. Technical support: TEL: 514-255-HELP (4357) FAX: 514-255-1367 Web: www.ifar.ca 7 P.1 70350 00149 0 GUIDE D’INSTALLATION PASSLOCK-SL2 Fabriqué au Canada - Rev.P - 05 / 12 / 2008 S i t e I n t e r n e t : h t t p : / / w w w. i f a r. c a Copyright © 2006, FORTIN AUTO RADIO INC - TOUS DROITS RÉSERVÉS MODULE PASSLOCK I, PASSLOCK II, SATURN, HUMMER H2, Démarreur VATS ET NEW GENERATION Interface DE de CONTOURNEMENT branchement Auto-Apprentissage pour Système de Sécurité et /ou à distance. Voir les SCHÉMA DE BRANCHEMENT CÂBLAGE / GUIDE DE CONNEXION Vert Bleu Orange/Noir Orange Mauve/Blanc Mauve Jaune/Noir Jaune Rouge Noir Bleu Blanc COMMENCEZ ICI 2 1 Branchement du filage au démarreur à distance/Alarme 12V Batterie (+) INSTRUCTIONS D’INSTALLATION ET DE PROGRAMMATION Connecteur 2 (Blanc): Déterminez le type de branchement selon votre véhicule (Voir GUIDE DES VOITURES, P.3). Effectuez les branchements selon le type d’installation (Voir SCHÉMA DE BRANCHEMENT, P.3). IGN Tourner la clef en position ignition. START 7 Le DEL clignote rapidement. VOUS AVEZ 4 SECONDES POUR: 8 Branchez le connecteur 1 (noir) dans le module PASSLOCK-SL2 . 9 Démarrez le véhicule avec la clef. IGN START Le DEL clignote lentement (1 à 6 fois). OFF 1 3 Relâchez le bouton de programmation. 6 Maintenez le bouton de programmation enfoncé. Branchez le connecteur 2 (blanc) dans le module PASSLOCK-SL2 . 2 2 5 OFF Connecteur 1 (Noir): Déterminez le type d’installation (Data-Link ou non Data-Link). Pour l’installation Data-Link assurez vous de la présence du connecteur Data-Link sur le démarreur. (Voir schéma 1(ci-dessous)). Pour installation non Data-Link voir schéma 2 (ci-dessous). 1.B ENTRÉE SORTIE Data-Link Data-Link Effectuez les connexions du PASSLOCK-SL2 : 1.A Branchement du filage au véhicule N.C. OFF 1 Masse (-) Masse d'activation Data In Barillet Data du BCM Bulb test OUT Key sense OUT Démarreur ou acc. IGNITION ou ACC. 4 Le DEL s’allume pour indiquer le début de la programmation. INSTALLATION SUR SYSTÈME AVEC DATA-LINK Schéma 1 En data-link les entrées analogues (déverrouillé, ground out) sont désactivées pour augmenter la sécurité. Démarreur ou alarme Port Data Link 2 1 10 IGN START Tournez la clef à OFF. LE PASSLOCK-SL2 EST PROGRAMMÉ. INSTALLATION SUR SYSTÈME SANS DATA-LINK Schéma 2 Coupez les 4 fils à l’extrémité de l’un des deux connecteurs Data-Link. Connectez le fil rouge au 12V et le fil vert à la masse du véhicule. Démarreur ou alarme 2 1 Rouge +12V INFORMATIONS / SUPPORT TECHNIQUE Ni le manufacturier, ni le distributeur ne se considèrent responsables des dommages causés ou ayant pu être causés, indirectement ou directement, par ce module, excepté le remplacement de ce module en cas de défectuosité de fabrication. Ce module doit être installé par un technicien qualifié. Ce guide d'instruction peut faire l’objet de changement sans préavis. consultez le www.ifar.ca pour voir la plus récente version. Support Technique: TEL: 514-255-HELP (4357) FAX: 514-255-1367 Web: www.ifar.ca P.2 INSTALLATION GUIDE PASSLOCK-SL2 Made in Canada - Rev. P - 05 / 12 / 2008 We b s i t e : h t t p : / / w w w. i f a r. c a Copyright © 2006, FORTIN AUTO RADIO INC - ALL RIGHTS RESERVED VEHICLES / VÉHICULES WIRING SCHEMATIC CONFIGURATION / SCHÉMA DE BRANCHEMENT 1 Vehicles Véhicules Buick Century LeSabre Park Avenue Rainier Regal Riviera Roadmaster Skylark Cadillac Allante Brougham Concours DeVille Eldorado Escalade Fleetwood Seville Chevrolet Astro Avalanche Blazer CK Pickup Camaro Caprice Cavalier Cavalier Cobalt Corvette Equinox Express Van Impala Lumina Malibu Monte Carlo S10 - S15 Silverado SSR Tahoe TrailBlazer GMC Canyon Envoy Jimmy Safari Savana Sierra Sonoma Suburban Yukon Hummer H2 Isuzu Ascender Hombre I-280 I-290 I-350 I-370 Oldsmobile Achieva Alero Aurora Bravada Cutlass Eighty-Eight Intrigue LSS Nighty-Eight Regency Pontiac Bonneville Firebird Grand Am Grand Am Grand Prix Pursuit Sunfire Sunfire Torrent Saturn Ion L Series S Series Vue Years Années Wiring schematic Schema de Branchement 1997-2005 1993-1999 1991-1996 2004-2007 1996-2004 1994-2000 1995-1996 1996-1998 1 1 1 4 1 1 1 2 1991-1993 1990-1996 1994-1999 1989-1999 1988-2001 1999-2005 1990-1996 1991-1995 1 1 1 1 1 4 1 1 1998-2005 2002-2006 1998-2005 1996-2006 1993-2002 1994-1996 1995-1999 2000-2005 2005 1989-2001 2004-2006 1998-2007 2000-2005 1995-2000 1997-2003 1995-2006 1998-2005 2000-2007 2004-2006 1997-2006 1999-2007 4 4 4 4 1 1 2 4 6 1 5 4 4 4 4 4 4 4 4 4 4 2001-2004 1998-2007 1998-2005 1998-2005 1998-2005 1998-2007 1998-2005 1998-2007 1998-2006 6 4 4 4 4 4 4 4 4 2003-2007 4 2003-2007 1998-2000 2005-2006 2007 2005-2006 2007 4 4 6 6 6 6 1996-1998 1999-2004 1995-1999 1998-2005 1994-1999 1995-1999 1997-2002 1997-1999 1995-1996 1997-1999 2 3 1 4 1 1 3 1 1 1 1996-1999 1993-2002 1995-1998 1999-2005 1994-1996 2005 1995-1999 2000-2005 2006 1 1 2 4 1 6 2 4 5 2003-2007 2000-2004 1998-2004 2002-2007 6 5 4 5 VATS Ground (-) (-) While running Data Data N.C. N.C. White Ground White (1V to 5V) 2 N.C. Ignition 12 V PASSLOCK 1 Note: Bulb test is a small black wire next to the 2 red 12V main power wires. Note: Buld test est un petit fil noir à côté des 2 fils rouge 12 V dans le connecteur noir. Black or Yellow Black Black/White or White 3 Ground (-) (-) While running Data Data Bulb Test Out 1 N.C. Starter +12V Ignition +12V PASSLOCK 2A Ground (-) (-) While running Data In Barrel Data from BCM 1 N.C. Yellow Black or Orange/Black White or Red/White 4 N.C. Starter +12V Ignition +12V PASSLOCK 2B Ground (-) (-) While running Data In Barrel Data from BCM 1 N.C. Yellow Black or Orange/Black White or Red/White 5 N.C. N.C. Ignition +12V Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow PASSLOCK 2C Ground (-) (-) While running Data In Barrel Data from BCM 1 N.C. Key sense Out Yellow Black or Orange/Black White or Red/White 6 Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow N.C. Ignition +12V Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow NEW GENERATION Ground (-) (-) While running Data In Barrel Data from BCM 1 N.C. White or White/Blue (V DATA) Accessory Ignition N.C. Accessory+12V Ignition +12V Green Blue Orange/Black Orange Purple/White Purple Yellow/Black Yellow WHAT IS DATA-LINK? / QU’EST-CE QUE LE DATA-LINK? Starter Alarm/ Dem. Alarme 2 way Data-Link Bypass /module de dérivation The Data-Link is a connection between the remote-Starter/Alarm and the Bypass/Interface module. This connection eliminates all other connections between devices by using bidirectionnal communication. It reduces the number of connections thus reducing installation error, and eliminates the risk of theft. It very easy to install and saves up 60% of the installation time. Le Data-Link est un connecteur entre le démarreur à distance/alarme et le module de contournent qui élimine tous les branchements entre ceux-ci, par le biais d'une communication bidirectionnelle. Il diminue les branchements et les erreurs d'installation. Il réduit les risques de vol. Il est facile à installer et sauve jusqu'à 60% du temps à l'installation. P.3