Kawasaki ER6N 12-13

KAWASAKI ER6-N 2012-2013
* The drawing is purely indicative
SHOCK ABSORBER AB2 MOUNTING INSTRUCTION
Original screw
A
Reservoir
bracket
C
Reservoir
screw
B
Remote pipe
D
Mounting instructions:
1. Remove the original seat from the bike.
2. Mount the shock absorber on the bike as shown in the picture.
3. Remove the original screw “A” positioned in the right side of the bike near the rear brake reservoir.
4. Fix the shock absorber reservoir inside the reservoir bracket “C” and fix all using the reservoir screw “B”.
5. Fix the reservoir bracket “C” in the right side of the bike using the original screw “A”.
6. Pay attention to position the remote pipe “D” as shown in the picture to avoid contact with the rear fender.
All of the operations of installation and dismounting, must be carried
out strictly by a specialised workshop.
Mupo cannot be held responsible for damage to products or persons
caused by incorrect installation or product tampering.
To install Mupo products, please follow the manufacturers
workshop manual instructions.
Before attempting to fit or remove any parts, protect the
motorcycle from possible damage.
MADE IN ITALY
Mupo Srl via dell’Artigianato 34, 40023 Castel Guelfo – Bologna (Italy) Tel. +390542671860 Fax. +390542671858 www.mupo.it – [email protected]