docfitting instruction - template
download 
Plainte Documents pareils
fitting instruction - template
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to tha...
Fitting Instructions
push in studs beneath). Remove 2 torx head screws around each wheel arch, 1 behind arch trim, remove push-in clips
along lower edge of bumper.) Remove and discard bumper beam. If chassis end stiffe...
fitting instruction - template
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to tha...
fitting instruction - template
5. Attach chosen neck (ZN) and Electrical Bracket (ZE).
6. Fully tighten all fixings to their correct torque setting.
7. Cut the bumper using below as a guide. Use existing fixings (G) to attach bu...
fitting instruction
Bar (A) using Bolts (L). Tighten all bolts. Re-fit heat shield using longer Bolt (N). Re-fit exhaust.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or...
